Presses Stock Sizes

Presses Stock Sizes

Please Note: These mappings are separate from the size range setup on the press and will be available for quoting without needing to fall into the defined range

To setup or edit the different stock sizes that can print on a particular press, go to Admin > Configure Factory > Equipment > Stock Sizes.

 


 


The following box will appear:

 


 


From here you enter the ‘Press’ and one by one, add the stock sizes that you print on this press. You also have to specify the ‘Leading edge’ for all sizes.

 





As you add each stock size to the press, it will appear at the bottom in the Current Press to Stock Size Mappings:

 


 

This information must be added for every stock size that will be printed on a particular press.

 

 


    • Related Articles

    • PRESSES - Setup and configure

      If you are setting up a new press or need to alter the configuration on an existing press, this is managed under Admin > Configure Factory > Equipment > Presses. This takes you to the 'Manage Presses' screen. Here you can see the list of all current ...

    • Mapping stocks to presses (new)

      MAPPING STOCKS TO PRESSES (new) Add specific rules for which stocks can be printed on each press.  Under Admin> Configure Factory > Equipment > Stocks. Begin by selecting the press you would like the stock rules mapped to: Select Type: Use ...

    • Setting Up A Press

      1. Creating a Press Diagram of overall process to build a press (PDF available in attachments): [v39] To create a press in printIQ go to the Admin Menu and following it down to Configure Factory From here go to the EQUIPMENT section and click on ...

    • Mapping stocks to presses (old)

          You will need to map the stocks to the presses you wish to print them on. Go into the stock mapping screen.     Add the stocks that you wish to map into the stock mapping section, tick on all stocks that you wish to map.     Choose what press you ...

    • PLATES - Map to presses - ORIGINAL LEGACY SETUP

      This is where you map the previously created ‘Plate and Toner’ items (originally setup in Inventory > Plates) to their corresponding presses. All this is managed under Admin > Configure the Factory > Equipment > Plates.       The following box will ...