PLATES - Map to presses - ORIGINAL LEGACY SETUP

PLATES - Map to presses - ORIGINAL LEGACY SETUP


This is where you map the previously created ‘Plate and Toner’ items (originally setup in Inventory > Plates) to their corresponding presses. All this is managed under Admin > Configure the Factory > Equipment > Plates.

 


 

 

The following box will appear:

 


 

You will see a list of all the plates and toners previously entered.

 

Select the plate you want to map and then select the press you want to map it to.

 


 

 

Click the ‘Go’ button and the mapping will appear at the bottom of the screen.


Follow this process for all the ‘Presses’ and ‘Printers’ you have.

 

REMOVING A PRESS TO PLATE MAPPING


If you need to delete a plate or tonner from a piece of equipment, you can just select the plate at the top and select the press you want it removed from at the bottom and click ’Go’. The mapping will now be removed.

 


 

 

 


    • Related Articles

    • PLATES - Create Plates - ORIGINAL LEGACY SETUP

        PLATES - Create plates   This is where you enter your plate details such as ‘make’, ‘size’ and ‘costs’. All this is managed from ‘Plates’ under ‘Inventory’ in the ‘Configure the Factory’ screen.       The following screen will appear. Here you can ...
    • Mapping stocks to presses (old)

          You will need to map the stocks to the presses you wish to print them on. Go into the stock mapping screen.     Add the stocks that you wish to map into the stock mapping section, tick on all stocks that you wish to map.     Choose what press you ...
    • Press Cost Component Definitions.

      The press cost component record drives the production times and the costs for the press record. There can be many component records that are engaged for different criteria. It is suggested that when building press component records you start out ...
    • Mapping stocks to presses (new)

      MAPPING STOCKS TO PRESSES (new) Add specific rules for which stocks can be printed on each press.  Under Admin> Configure Factory > Equipment > Stocks. Begin by selecting the press you would like the stock rules mapped to: Select Type: Use ...
    • Press Options - Restricting production paths calculated

      Introduction ‘Press Options’ allow setting up multiple configurations for a single physical press. In flexographic environments the number of options can be substantial, based on the cylinder options defined. At quote time, each of these ‘Press ...