Finish Sizes
This is where you enter all the ‘sizes’ you wish to offer. These will show in the custom quoting 'Finished Size' dropdown list for you to select from.
This is managed under Admin > Configure the Factory > Finish Sizes.
The following box will appear:
From here you enter the name and dimensions of all required sizes.
You can also specify an 'Order' number. This helps you set the order that the sizes show
in the dropdown list when quoting. The higher the number the further down the list it will show.
As you add each size, it will appear at the bottom of the screen as shown:
This information must be added for each size you wish to use. You can use custom sizes when quoting but all standard sizes should be entered here.
* There is also an option to enter a 'Height' for any 3D products:
Related Articles
Stock - Inventory Stock Sizes
How to set up Stock sizes are created under Admin/Configuration: Inventory / Stock Sizes: This will open an admin screen listing all existing stock sizes: The ‘Search’ fieed can be used to search specific sizes: Click the ‘Edit’ icon to edit an ...Presses Stock Sizes
Please Note: These mappings are separate from the size range setup on the press and will be available for quoting without needing to fall into the defined range To setup or edit the different stock sizes that can print on a particular press, go to ...Stock Size Cutting Rules (Pre-Trim)
If you are setting stocks up that are trimmed out of larger sheets (Pre-Trim), you need to setup the ‘cutting rules’ so that you are able to quote on smaller sheet sizes that are able to fit on the presses that you have in the system. You will ...STOCK - Adding a new stock size from within a quote
A new stock size can be added to a stock record directly from a quote. This is handy when you are quoting a job and require a stock size that does not exist against the selected stock. When quoting, we have the 5 set sizes available as well as any ...OUTSOURCE - Supplier Portal – Automatic Update Job to Finish Production
Overview To assist with minimising touch points within certain workflows, we can now automatically update a ‘Job Status’ to ‘Finished Production’ on a fully outsourced job when the outsource ‘Suppliers Invoice’ has been entered against the outsource ...